How to Install TWRP Recovery and Root Doogee BL7000

Install TWRP Recovery and Root Doogee BL7000: TeamWin recovery project or simply TWRP recovery is software that allows you to install unofficial firmware on your device. Most people prefer to use TWRP recovery because it has a touch-based user interface which makes flashing an image very simple. Earlier it supports only Nexus devices but now it is available for a wide range of phones. It also comes with various customizations supports such as gaining root access, making a Nandroid backup, installing a custom kernel, removing bloatware etc. It has an XML based Graphic User Interface which gives an advantage of modifying the recovery, ultimately makes it the best android custom recovery.

If you are a user of Doogee BL7000, then there is incredibly good news for you. You have the opportunity to easily root your device by installing TWRP. All that is needed is unlocking the bootloader of your device which will grant you the root access on your phone with the assistance of TWRP recovery.

The whole process is fairly simple and can be completed within 10-15 min. We have already mentioned that one of the most preferred uses of TWRP recovery is that you can use it to flash custom ROMs on your device with the help of stock recovery. So let us see How to Install TWRP Recovery and Root Doogee BL7000.

Pre-requisites

1. This guide only for Doogee BL7000.
2. Remember to take a backup of your files before beginning to install TWRP and root your device.
3. Your device must have more than battery to prevent the sudden shutdown.

Downloads

ADB and Fastboot Drivers

Toolkit with Require Files Doogee BL7000 – Link Broken

Steps to Install TWRP Recovery and Root Doogee BL7000

Install TWRP Recovery

1. Download and Install ADB drivers on your PC.
2. Now, download Doogee BL7000 Toolkit zip file
3. Extract the Doogee BL7000 Toolkit zip file in the new folder.
4. Enable the USB debugging on your device after enabling ‘Developer Options’ by going to ‘About phone’ and tapping build number 7 times.
   
5. Connect Doogee BL7000 to PC using USB cable.
6. In your PC, Run the Doogee BL7000 toolkit.exe. (Double Click)
7. Now Type 41, hit enter to start flashing TWRP Recovery.
8. It Will take few seconds to flash TWRP recovery on your device.
9. Now, You device will automatically booted into TWRP recovery mode.
   └ If not long press “Volume down + Power” buttons until your device boots into recovery mode.

Root Doogee BL7000

• Connect Doogee BL7000 to PC using USB cable.
• Make sure that your device is in TWRP Recovery mode.
  └ If not long press “Volume down + Power” buttons until your device boots into recovery mode.
• In your PC, Run the Doogee BL7000 toolkit.exe. (Double Click)
• Now, type 45 and hit enter (All required files will be transferred into your device)
• In TWRP Main menu, Take a full Nandroid Backup.
• Now in the TWRP main menu, Click on Wipe and swipe to factory reset on the bottom of the screen.
• Go back to the main menu in TWRP, tap on install and select the Noverity zip file and do swipe to confirm flash to begin the installation process.
  
• Again, go back to the main menu in TWRP, tap on install and select the xnmagisk zip file and do swipe to confirm flash to begin the installation process.
• After flashing magisk and Noverity, reboot your device from the main menu.
• Done!!!

Hope you have installed TWRP Recovery and Root Doogee BL7000. Let us know if you have any queries in the comment section below.